COTS PRODUCTS> COTS DIGITAL / ANALOG PRODUCTS > CARRIER / ADAPTERS PRODUCTS > AT-PMC-XMC-Adapter
 
Adapt one XMC.3 (PCI Express VITA 42.3) card to a PMC slot
PCI Express x1 lane interface
PMC Compliant to IEEE P1386.1 specifications
32 bit /33 MHz/66 Mhz
Three 64 pin PMC connectors
Two 114 pin XMC connectors
Supports 3.3V PCI signaling
Selective Active signal equalization and compensation for robust operation in any personal computer
IEEE 1384 XMC mechanicals
Transparent operation
Standard XMC card size (143.75 mm x 74 mm)
Conduction cooling (VITA20) for card
Optional conformal coating
 

The PMC to XMC adapter allows XMC card to be used in a PMC slot. The XMC site is VITA 42.3 compatible and supports a single (X1) PCI Express lane. The product will work with 33 MHz and 66 MHz clock speeds and with 32-bit bus width. Appears transparent to the system, hence no additional drivers are required for operating the adapter. The carrier card acts simply as an adapter to route PMC bus signals to and from the XMC card. All ATs XMC cards and those from other vendors are supported. This card is well suited for enterprise router/switch/gateway providers and system integrators. The carrier is optionally available with a conformal coating layer.

Software
No software required
Applications
Add XMC cards to standard PMC slots
Custom interfaces to XMC P16
Multi-card system synchronization and control
Mezzanine Slots
One PMC Slot
32bit, 33 MHz or 66MHz
XMC Site
XMC Compliant to VITA 42.3
PMC Compatibility
PMC compliant as per the IEEE 1386 specification
Physical
Standard Singlewide XMC (143.75 mm x 74 mm)
Environmental
Operating Temperature: -40C to +85C
Storage Temperature: -55C to +100C
Relative Humidity: 5% to 95% (non-condensing)
Power
Supply +5V, +3.3V, +12V and -12V from PMC Connectors are used
An on-board voltage regulator is used to generate 1.5V
Software Interface
No software set-up required by PMC to XMC adapter
Warranty
1 year limited warranty
 
CORPORATE   ABOUT   FOLLOW US ON
AdTEC Electronics Inc.
4677 Old Ironsides Drive
Ste 230 Santa Clara
California 95054, USA
 
AdTEC Electronics specializes in providing end-to-end custom product design & development encompassing System, Mechanical, Board Electronics, Chip design, Firmware and Application Software Engineering. Our design capabilities include design for testability and rugged design to meet both commercial and stringent regulations.
 
HOME ABOUT US COTS PRODUCTS SERVICES & SOLUTIONS SUPPORT & RESOURCES NEWS & EVENTS BLOG CONTACT US
AdTEC Electronics Inc.